Basics
Before you start
The pieces, the color scheme and how to read the moves.
The pieces
- 24 centersFour per face. Nothing holds them in place, so you build each center yourself.
- 24 edgesTwo per edge. Each pair has the same two colors.
- 8 cornersThey behave just like the corners of a 3×3.
The color scheme
No center is fixed, so the cube can't show you where each color belongs. Use the standard scheme:
- White is opposite yellow
- Green is opposite blue
- Red is opposite orange
Hold white on top and green in front: red is on the right, orange on the left and blue at the back. Building the centers in the wrong order makes the cube impossible to finish, so check this before you start stage 1.
Reading the moves
RLUDFB- Right, left, up, down, front, back. Turn that face a quarter turn clockwise, as if you were looking straight at it.
R'- A prime means counterclockwise.
R2- A half turn. Either direction works.
Rw- Wide: the two right layers together.
Uw,Fw,Lw,DwandBwwork the same way. r- Only the second layer from the right, also written 2R.
xyz- Turn the whole cube in your hands: x follows R, y follows U, z follows F.
R U R'Tap a move to see it on the cube.
Centers
Build six solid 2×2 centers.
A 4×4 has 24 center pieces, four of each color, and they move around freely. Gather each color into a 2×2 block. Edges and corners don't matter yet, so they're grey in the examples, and the flat map under each cube shows all six faces at once.
1.1White center
Build white on top. Wide turns do the work: Rw, Lw, Fw and Bw each carry a column of center pieces from one face to the next.
- Lift white pieces onto the top with a wide turn.
- Before you lift, turn the top (
U) so the white pieces already there aren't in the column that's about to move. - Make a 1×2 bar first, then a second bar, then join them.
A white center, start to finish
Rw tucks the right-hand white piece away, U slides the other one along, and Rw' brings the first one back: now they form a bar. U turns the bar to the right, and Lw2 lifts the second bar from the bottom into the gap.
1.2Yellow center, opposite white
Turn the cube over (x2) so white is on the bottom. From now on, any slice you turn has to be turned back, or you'll break the white center. This three-move insert only swaps pieces between the top and the front, so white is never touched:
- Turn the whole cube (
y) until a yellow piece is on the front. - Turn
Funtil that piece sits at the bottom-right of the front center. - Turn
Uuntil the back-left spot of the top center is empty (not yellow). - Do
Rw U Rw'. The piece lands at the front-left of the top.
One insert
The yellow piece starts at the front's bottom-right and the gap is at the back-left of the top. Three moves later the yellow center is complete.
A whole yellow center
Three pieces, three inserts. Each one starts with a short setup: a y to find a yellow piece, an F turn to put it at the bottom-right, a U turn to move the gap to the back-left.
Shortcut: two at once
If two yellow pieces are stacked in the front's right column, Rw U2 Rw' swaps that whole column with the left side of the top. Turn U first so the top's left side is the empty half.
1.3The third center
Hold the cube with white on the left and yellow on the right. Rw and Lw only move the top, front, bottom and back, so they can't disturb white or yellow. Build green on top exactly the way you built white, using Rw, Lw and turns of U, F, D and B.
Green on top
The same bar trick as the white center. White and yellow stay put on the sides the whole time.
1.4The fourth center
Tilt the cube (x) so green goes to the back. Orange goes on top now: with white on the left, yellow on the right and green at the back, the top of a solved cube is orange. Insert orange pieces with the same rule as before, gap at the back-left of the top:
- From the front: piece at the front's bottom-right, then
Rw U Rw'. - From the bottom: piece at the back-right of the bottom center, then
Rw2 U Rw2.
Both leave white, yellow and green alone.
Orange from the front and the bottom
One piece comes up from the front, two come up from the bottom. A D turn moves a bottom piece to the back-right, a U turn moves the gap.
1.5The last two centers
Tilt the cube again (x). Green is now on the bottom and orange at the back, so blue belongs on top and red in front. Keep inserting blue pieces from the front with Rw U Rw' until the top is all blue. The front turns red by itself.
Blue on top, red in front
Two inserts. All six centers are done after this.
Edges
Pair the 24 edge pieces into 12 double edges.
Each edge of a 4×4 is two pieces with the same two colors. Your job is to get every matching pair side by side. One algorithm does it, and it puts the centers back when it's done. In the examples the corners are grey, and only the two pieces being paired are in color.
2.1Pair two pieces
- Find two edge pieces with the same two colors.
- Put one in the front-right edge and the other in the front-left edge, both in the bottom half. They'll show the same color toward you. Use outer turns for this (
R,L,U,D,F,B), which never move the centers. - Do
Dw R U R' F R' F' R Dw'. The left piece moves over and joins its partner on the right. - Move the finished pair into the top or bottom layer, for example with
R U R'. Pairs are safe there.
Two pieces become one edge
Dw slides the bottom half a quarter turn. The seven moves in the middle swap the two halves of the right edge. Dw' slides the bottom half back, which puts the centers back too.
2.2When they're at different heights
If one piece is in the top half and the other in the bottom half, flip the right edge first with R U R' F R' F' R. Those are the same seven moves as in the middle of the pairing algorithm: they swap the top and bottom halves of the front-right edge and leave the front-left edge alone. If both pieces are in the top half, F2 drops them both to the bottom.
Flip, then pair
The right-hand piece starts high. The flip brings it down to the bottom half, level with its partner, and the pairing algorithm finishes the job.
2.3The last two edges
Pairing always leaves a spare piece behind in the front-left edge, so you finish with two unpaired edges. Put them in the front-left and front-right edges. If the two bottom pieces match each other, one pairing algorithm closes both edges at once. If they don't, flip the right edge first, as in 2.2.
Both edges in one go
The bottom pieces match, and so do the top pieces. After the algorithm all twelve edges are paired.
Solve it like a 3×3
Outer turns only from here on.
Treat every 2×2 center as one center and every pair as one edge, and turn only the outer layers (R, L, U, D, F, B). If you can already solve a 3×3, do that now and keep stage 4 handy. If not, here's a beginner's method with white on the bottom and yellow on top.
3.1White cross
First make a daisy: get all four white edges onto the top around the yellow center, white facing up. If a white edge is in the middle layer, turn its side face to bring it up, but turn U first so you don't knock off a petal you already have.
Then, for each petal, turn U until its side color matches the center below it, and turn that face twice. It drops into place on the bottom.
From daisy to cross
Four petals, each matched to its center and dropped with a half turn. The map shows the cross forming on the bottom.
3.2White corners
Find a white corner in the top layer. Turn U until it sits above its spot, between the two centers that match its other colors, and hold the cube so that spot is at the front-right. Repeat R U R' U' until the corner drops in the right way round. That takes 1, 3 or 5 repeats.
A white corner stuck in the bottom layer in the wrong place: hold it at the front-right and do R U R' U' once to bring it up.
Three repeats
White faces right at the start, so this corner needs three repeats.
3.3Middle layer
Find an edge in the top layer without any yellow. Turn U until its front color matches the front center, then check its top color:
- Matches the right center:
U R U' R' U' F' U F - Matches the left center:
U' L' U L U F U' F'
An edge in the middle layer but wrong: insert any top edge into its slot to pop it out, then insert it properly.
Insert to the right
Green faces the green center and orange sits on top, matching the orange center on the right.
Insert to the left
Green faces the green center and red sits on top, matching the red center on the left.
3.4Yellow cross
Look only at the yellow edges on top and do F R U R' U' F' as often as you need:
- Dot: do it once to get an L.
- L: hold the L at the back-left and do it to get a line.
- Line: hold it left to right and do it to get the cross.
One or three yellow edges? A 3×3 can't do that, so it's parity. Fix it with step 4.1, then come back.
Dot, L, line, cross
Only yellow stickers are colored on the top layer, since that's all this step looks at.
3.5Yellow face
Count the yellow corners on top, hold the cube as below, and do R U R' U R U2 R', known as the Sune. Repeat until the top is all yellow.
- None: turn
Uuntil the front-left corner shows yellow on its left side. - One: turn
Uto bring it to the front-left. - Two: turn
Uuntil the front-left corner shows yellow facing you.
Two Sunes
No yellow corners at first. After one Sune there's one, which goes to the front-left for the second Sune.
3.6Yellow corners
Look at the sides of the top layer for two corners with the same color on one side. Cubers call them headlights. Hold the headlights at the back and do R' F R' B2 R F' R' B2 R2. No headlights anywhere? Do it once from any side, and they'll appear. Finish by turning U to line the corners up with the centers.
Headlights to the back
The matching corners are on the front at the start. U2 sends them to the back, then the algorithm places the other two.
3.7Yellow edges
Hold a fully solved side at the back and do R U' R U R U R U' R' U' R2. If the edges still aren't right, do it once more. No solved side? Do it once from anywhere, then look again.
Two edges need to swap and nothing else? That's the other kind of parity: see step 4.2.
The last three edges
Turn the whole cube (y2) to put the solved side at the back. This case needs the algorithm twice.
Parity
Two positions a 3×3 never shows you.
Pairing edges can leave the 4×4 in a position no 3×3 can reach. You didn't make a mistake: it comes from the way the edges happened to pair up. Each case has one fix, and about three solves in four need at least one of them.
4.1OLL parity: one flipped edge
When you'll see it: at the yellow cross, there are one or three yellow edges on top. Hold the cube with a non-yellow edge at the front and do:
Rw U2 x Rw U2 Rw U2 Rw' U2 Lw U2 Rw' U2 Rw U2 Rw' U2 Rw'
It flips that edge and leaves the first two layers alone. The rest of the top layer gets mixed up, which doesn't matter: go back to the yellow cross. The x halfway through means turn the whole cube like an R move, then carry on.
Three edges become four
U brings the flipped edge to the front. After the algorithm all four yellow edges are up.
4.2PLL parity: two swapped edges
When you'll see it: at the very end, two edges need to swap and everything else is solved. Hold the two edges at the front and back and do:
r2 U2 r2 Uw2 r2 Uw2, then U2
r2 turns only the second layer from the right; Uw2 turns the top two layers. If the two edges are next to each other instead, do the algorithm and U2 from any side, then finish with step 3.7.
Swap front and back
The green and blue edges are swapped. Six moves and a U2 later, the cube is solved.
Reference
Cheat sheet
All 14 algorithms on one screen.
| Step | Algorithm | Use it when |
|---|---|---|
| 1 · Centers | ||
| Insert from the front | Rw U Rw' | Piece at the front's bottom-right, gap at the top's back-left. |
| Insert a bar | Rw U2 Rw' | Two pieces stacked in the front's right column, top's left side empty. |
| Insert from the bottom | Rw2 U Rw2 | Piece at the back-right of the bottom center, gap at the top's back-left. |
| 2 · Edges | ||
| Pair | Dw R U R' F R' F' R Dw' | Matching pieces at the bottom of the front-left and front-right edges. |
| Flip the right edge | R U R' F R' F' R | The matching pieces are at different heights. |
| 3 · Like a 3×3 | ||
| White corners | R U R' U' | Corner above its spot at the front-right. Repeat until it's in. |
| Middle edge, right | U R U' R' U' F' U F | Front color matches, top color matches the right center. |
| Middle edge, left | U' L' U L U F U' F' | Front color matches, top color matches the left center. |
| Yellow cross | F R U R' U' F' | Dot, L at the back-left, or line held left to right. |
| Yellow face (Sune) | R U R' U R U2 R' | Hold by the number of yellow corners, repeat. |
| Yellow corners | R' F R' B2 R F' R' B2 R2 | Headlights at the back. |
| Yellow edges | R U' R U R U R U' R' U' R2 | Solved side at the back, repeat if needed. |
| 4 · Parity | ||
| OLL parity | Rw U2 x Rw U2 Rw U2 Rw' U2 Lw U2 Rw' U2 Rw U2 Rw' U2 Rw' | One or three yellow edges up. Flipped edge at the front. |
| PLL parity | r2 U2 r2 Uw2 r2 Uw2 U2 | Only two edges swapped. Hold them front and back. |